SEIDIO OBEX® for Samsung Galaxy S III Installation Video

Seidio OBEX™ Installation Video

Install:

Before you begin installation on the OBEX™ case, always read through the manual and conduct a visual inspection for any damage, and complete a waterproof test. Do not use a damaged case for protection.

Double check to make sure you do not have any third party screen protectors and full body wraps on the device itself. Leaving those protectors on may adversely affect the fitment of the OBEX, and may cause water leak and damage your device. Remove all of them before proceeding.

Remove the screen protector film from the case and begin the installation. Open the bottom latch and insert a coin into the slot found next to the USB flap; twist and separate the two halves. Use your hands and gently pry the two halves apart. Please note that the water-sealing gasket and flaps may come loose as part of the process. Remember to put them back in their places when you are ready to assemble the case again.

You are now ready to install! Insert the device facing down into the top half of the case, gently press the device on all four corners to make sure it is in all the way.

Make sure both flaps are in its place and the gasket is securely inside its groove, place the bottom half of the case onto the top half. Press the two halves tight together so no gasket is showing through the seam. Close the bottom latch by snapping it into place.

Uninstall:

Dry off the case of any liquids or particles before removing the case. Open the bottom latch and wipe off any excess water or liquid inside the latch. This is normal and will not damage your device.

Using a coin, insert it into the slot next to the USB flap, twist to separate the two halves. Use your hand and gently pry the two halves apart. Please note again that the gasket and flaps may come loose as part of the process. Remember to put them back in their places when you are ready to assemble the case again.

Place the top half of the case with the device in your hand so that the screen is facing down, gently twist the case from the sides so the device comes free from the case. Remove the device from the case.

Remember to place loose flaps and gasket back onto the case before your next installation. For complete installation instruction, or to find out more about your new OBEX case, refer to the included instruction manual or visit www.seidio.com/obex.

Learn more @ www.seidio.com/obex
www.seidioonline.com